|
Management
|
SNMP v1 v2c, v3/ Web/Telnet/CLI
|
|
SNMP MIB
|
RFC 1213 MIBII
RFC 1158 MIB
RFC 1157 SNMP MIB
RFC 1493 Bridge MIB*
RFC 1573 IF MIB
RFC 2674 Q-Bridge MIB*
RFC 2819 RMON MIB
Private MIB
|
|
ITU G.8032
|
Support ITU G.8032 for Ring protection in less than 20ms for self-heal recovery (single ring enhanced mode)
Support basic single ring & enhanced ring
Enhanced G.8032 ring configuration with ease
Cover multicast & data packets protection
|
|
PoE Management
|
PoE Detection to check if PD hangs then restart the PD
PoE scheduling
|
|
Per Port PoE Status
|
On/ Off, voltage, current, watts, temperature
|
|
User friendly UI
|
-
Auto topology drawing
-
Topology demo
-
Complete CLI for professional setting
|
|
Port Trunk with LACP
|
LACP Port Trunk: 8 Trunk groups
|
|
LLDP
|
Supports LLDP to allow switch to advise its identification and capability on the LAN
|
|
CDP
|
Cisco Discovery Protocol for topology mapping
|
|
Environmental Monitoring
|
System status for actual input voltage, current, total power load and ambient temperature to be shown in GUI and sent alerting if any abnormal status
|
|
VLAN
|
Port Based VLAN
IEEE 802.1Q Tag VLAN (256 entries)/ VLAN ID (Up to 4K, VLAN ID can be assigned from 1 to 4096.)
GVRP
Protocol based VLAN, Subnet based VLAN
|
|
IPv6/4
|
Present
|
|
Spanning Tree
|
Supports IEEE802.1d Spanning Tree and IEEE802.1w Rapid Spanning Tree, IEEE802.1s Multiple Spanning Tree 8 MSTI
|
|
Quality of Service
|
The quality of service determined by port, Tag and IPv4 Type of service, IPv4 Differentiated Services Code Points - DSCP
|
|
Class of Service
|
Support IEEE802.1p class of service, per port provides 8 priority queues
|
|
Remote Admin
|
Supports 10 IP addresses that have permission to access the switch management and to prevent unauthorized intruder.
|
|
Login Security
|
Supports IEEE802.1X Authentication/RADIUS
|
|
Port Mirror
|
Support 3 mirroring types: “RX, TX and Both packet”
|
|
Network Security
|
Support 10 IP addresses that have permission to access the switch management and to prevent unauthorized intruder.
802.1X access control for port based and MAC based authentication/static MAC-Port binding
Ingress/Egress ACL L2/L3
SSL/ SSH for Management
HTTPS for secure access to the web interface
TACACS+ for Authentication
|
|
IGMP
|
Support IGMP snooping v1,v2,v3; 256 multicast groups; IGMP router port ; IGMP query; GMRP
|
|
MLD Snooping
|
Support IPv6 Multicast stream
|
|
Static multicast forwarding
|
Static multicast forwarding forward reversed IGMP flow with multicast packets binding with ports for IP surveillance application
|
|
Bandwidth Control
|
Support ingress packet filter and egress packet limit.
The egress rate control supports all of packet type.
Ingress filter packet type combination rules are Broadcast/Multicast/Flooded Unicast packet, Broadcast/Multicast packet, Broadcast packet only and all types of packet.
The packet filter rate can be set an accurate value through the pull-down menu for the ingress packet filter and the egress packet limit.
|
|
Flow Control
|
Supports Flow Control for Full-duplex and Back Pressure for Half-duplex
|
|
System Log
|
Supports System log record and remote system log server
|
|
SMTP Trap
|
Supports SMTP Server and 8 e-mail accounts for receiving event alert; can send SMS** text alert via mobile
|
|
Relay Alarm
|
Provides one relay output for port breakdown, power fail and alarm.
Alarm Relay current carry ability: 1A @ DC24V
|
|
Protection
|
-
Miss-wiring avoidance
-
Node failure protection
-
Loop protection
|
|
SNMP Trap
|
Up to 5 trap stations; trap types including:
-
Device cold start
-
Authorization failure
-
Port link up/link down
-
DI/DO open/close
-
Typology change(ITU ring)
-
Power failure
-
Environmental abnormal
|
|
PXE
|
PXE to verify switch firmware with the latest or certain version
|
|
DHCP
|
Provide DHCP Client/ DHCP Server/DHCP Option 82 (Client & Server)/Port based DHCP; DHCP Option 66; IPv6 address resolution for DHCP server**
|
|
Mac based DHCP Server
|
Assign IP address by Mac that can include dumb switch in DHCP network
|
|
L3Lite
|
Lantech OS3 and OS4 are optional upgradable to L3 Lite for future expansion. The optional L3Lite includes editable routing table, VRRP, Router-on-a-stick, Inter- VLAN routing
|
|
DNS
|
Provide DNS client feature and support Primary and Secondary DNS server.
|
|
SNTP
|
Supports SNTP to synchronize system clock in Internet
|
|
Firmware Update
|
Supports TFTP firmware update, TFTP backup and restore; HTTP firmware upgrade
|
|
Configuration
upload and download
|
Supports text configuration file for system quick installation; Support factory reset button to restore all settings back to factory default; USB for auto restore/backup
|
|
Diagnostic
|
Support Ping, ARP table and DDM information
|
|
Dual Image Firmware
|
Support dual image firmware function
|
